Reply With Quote
ummmmm thats first digital one I ever seed
Powerlineman® Sponsors
|
|
Results 1 to 6 of 6
Thread: more welsh work today
-
02-26-2013, 08:25 AM #1
Senior Member
- Join Date
- Sep 2009
- Location
- ireland/ Dublin
- Posts
- 2,119
more welsh work today
Featured SponsorBit of welsh work TODAY....... Including digital dyno.
IF IT WASN'T FOR BAD LUCK WE WOULD HAVE NO LUCK AT ALL. !
-
02-26-2013, 09:41 AM #2
Senior Member
- Join Date
- Oct 2006
- Location
- South East Texas
- Posts
- 3,278
-
02-26-2013, 01:25 PM #3
Senior Member
- Join Date
- Sep 2009
- Location
- ireland/ Dublin
- Posts
- 2,119
Today
Originally Posted by Pootnaigle
Today it was set at 1.65 tons coz it was 4 degrees. " NIPPY "IF IT WASN'T FOR BAD LUCK WE WOULD HAVE NO LUCK AT ALL. !
-
02-26-2013, 02:26 PM #4
Senior Member
- Join Date
- Jun 2007
- Posts
- 6,233
You got me beat,Poot...I cant recall seeing any type
-
03-02-2013, 07:48 AM #5
Senior Member
- Join Date
- Dec 2010
- Location
- Ontario, Canada
- Posts
- 1,012
We use digital dynos all the time, but they get screwy when the batteries get low. The first time I used them to sag , I ended up giving them to the foreman to get them re-calibrated , because the sag on 3 phases wasn't even close to even.
-
03-03-2013, 07:54 AM #6
Senior Member
- Join Date
- Sep 2009
- Location
- ireland/ Dublin
- Posts
- 2,119
One
Featured SponsorrWe've only the one dyno. But we are only pulling one wire at a time so not a problem. We pull the middle up to tension then reg the out side two up to it. We only use the dyno as a rough guide. On the outter two. Looks better if done by EYE.
IF IT WASN'T FOR BAD LUCK WE WOULD HAVE NO LUCK AT ALL. !
